Without the need for manual removal

February 15th, 2010 by admin

Once the connection (anastomosis) is complete, a blue contrast material is introduced through the cervix, moving along the uterus and tubes, all the way to the abdominal cavity. This is done to ensure that the fallopian tubes have been aligned the right way and that the joining is working properly.All surgical instruments are removed out, the gas is drawn from the abdomen, and the patient is woken up and moved to the recovery room to be observed and cared for by the nurses, as well as by the anesthetist who makes sure the patient is well and free from any problems. On the average, two to 4 hours afterwards almost all patients are discharged.Patients are seen 1 week after the surgery to look at the small surgical incisions and remove any stitches if required. Usually,  the few stitches that were placed will be below the skin and will be degraded by the body, without the need for manual removal.Persons should wait 2 to 3 months prior to seeking to become pregnants in order to give the fallopian tubes a chance to heal entirely. Trying to conceive before may result in a higher risk of ectopic pregnancy (i.e. pregnancy in the fallopian tubes in place of in the uterus).When performed by a experienced laparoscopic or outpatient tubal reversal surgeon, laparoscopic tubal reversal combines the success rate of micro-surgical techniques with the plus points of minimally-invasive surgical procedures i.e. faster recovery, improved healing, less pain, fewer problems, and no large disfiguring scars.

Posted in Health